Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have been using 27C256 (EPROM) which has the option of putting a .bin , .hex file which is already been programmed. But the problem is how to build .hex or .bin file. I tryed a Microntroller program's hex file. That was good but unfortunatly i Don't know the what that code has or how to change it or in other words how to build a custom .hex file. Because my code is custom code not a Specific IC's, Processor or Microcontroller. I am attaching my project file for which i need memory Block or IC.
The Project is basically an custom 8-bit microprocessor from gate level. Although its incomplete without memory block.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
