Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Geometry stitch failed warning in HFSS

Status
Not open for further replies.

mishrashashi

Advanced Member level 4
Joined
Jan 5, 2011
Messages
105
Helped
20
Reputation
40
Reaction score
20
Trophy points
1,298
Location
India
Activity points
1,912
Hi all,
I am doing HFSS simulation for combination of FR4 PCB and Metal PCB. My simulation failed after running several hours. There was a warning message-"Geometry Stitch Failed. Falling back to backup process".

I'm using HFSS 15.0 (64 bit) for analysis.
Can anyone give me idea what is this warning message and how to get rid of this?
 
Last edited:

I have the same warning following by 2 errors
HFSS 15 x64 too
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top