evoplus
Member level 1
Hi,
Just like to check with you guys have you encountered a case where under the setup boundaries/ sources, I wanted to select th two taper line( indicate in red) for the boundary but I don't seem to be able to select them? What could be the problem? I'm currently using the HFSS 8.
Thanks
Just like to check with you guys have you encountered a case where under the setup boundaries/ sources, I wanted to select th two taper line( indicate in red) for the boundary but I don't seem to be able to select them? What could be the problem? I'm currently using the HFSS 8.
Thanks