Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Usb hub usb2514 implementation doubt

Status
Not open for further replies.
J

Jishnu Rajeev

Newbie level 3
Joined
Sep 21, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,305
Usb hub usb2514 - implementation doubt

I'm using USB2514 to design a BUS powered system which has 3 devices to be connected at present . My doubt is regarding the SUSP_IND/LOCAL_PWR/NON_REM0 pin .

My system is bus powered so the pin has to be LOW . The device on my port 1 is non removable so the pin has to be HIGH . How this can be implemented ?? ( I know NON_REM0 is asserted only during RESET_N ... )Any RC arrangement or something like that . . I'm bit confused in this .

The datasheet link is : **broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top