Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help with single wire modeling in HFSS

Status
Not open for further replies.
J

jjftt

Newbie level 6
Joined
Jul 24, 2007
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,335
I try to model a single wire in HFSS and export the RLC parameters. I modeled, simulated and exported a lump model. But the resistance of the wire is very small. It seems that the capacitance is reasonable. Please help me. thank you. the attached is the project and the exported lump model. the R should be about 100 om. But in the file it is about 2 om. Thank you.
 

Attachments

  • wire_model.rar
    20.8 KB · Views: 94

help me, thank you.
 

Is there a reason you have no boundary conditions on the outside of your air box? HFSS will automatically set the boundaries to PECs in this case. My guess is, you're coupling to some other mode with these PECs.
 
  • Like
Reactions: jjftt

    J

    jjftt

    Points: 2
    Helpful Answer Positive Rating
In this case, the metal is inside the silicon dioxide, the boundary is ground or PECs. I think the boundary is OK. Yes, it seems that there is another parallel path for the wave. But i could not find this. PlanarMetamaterials , thank you.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top