Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

555 timer circuit help

Status
Not open for further replies.
L

LKSH

Junior Member level 1
Joined
Apr 8, 2013
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,405
hi
i want to build a buzzer circuit that gives beep sound and glows one led for 1-2 second at an interval of 5 second with 555 timer.
please give me a circuit diagram or any other alternative circuit using another ic which should cost low
 

use 555 as a astable multivibrator use a buzzer of 12vdc

- - - Updated - - -

use this ckt
 

Attachments

  • circuit_diagram_adjustable_astable_multivibrator_555.gif
    circuit_diagram_adjustable_astable_multivibrator_555.gif
    5 KB · Views: 124

where should i fit buzzer and what is the function of potentiometer p1 p2
 

pradeep.g.belchada said:
p1 & p2 sets the on state & off state buzzer can be directly fitted to the pin 3
Click to expand...

depends on the type of buzzer and current draw. piezo should be fine, mechanical is another story

- - - Updated - - -

you might to use a 556 - a dual 555 - one to set the 5 second interval and another to generate a [pleasant] tone for the speaker
 
  • Like
Reactions: LKSH

    L

    LKSH

    Points: 2
    Helpful Answer Positive Rating
kam1787 said:
depends on the type of buzzer and current draw. piezo should be fine, mechanical is another story

- - - Updated - - -

you might to use a 556 - a dual 555 - one to set the 5 second interval and another to generate a [pleasant] tone for the speaker
Click to expand...

hey kam1787 can u give me circuit diagram of 556 or dual 555
 

there are hundreds available on the internet. Try searching on "555" or "555 astable" or "555 flasher"
 

Hey Pradeep where do I fit buzzer?
In place/paraller of 'led' or ''led1and r3 combination''?
I had brought buzzer which works in range of 1.5-27 volt.
Can u post pcb layout also.
Thx in advance
 

buzzer can be fitted on pin3 to gnd (i mean -ve of battery.) place +ve of buzer to pin . this small ckt can be easily assembled on veroboard . general purpose pcb
 
  • Like
Reactions: LKSH

    L

    LKSH

    Points: 2
    Helpful Answer Positive Rating
pradeep.g.belchada said:
buzzer can be fitted on pin3 to gnd (i mean -ve of battery.) place +ve of buzer to pin . this small ckt can be easily assembled on veroboard . general purpose pcb
Click to expand...

can i increase the duration between on and off of buzzer?
i have built this ckt & it works like a charm but i m thinking of increasing the duration of buzzer off time
thx in advance
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top