Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i make a boost converter 500hz 15 to 30v but as i simulate it the output voltage drops slowly
why my voltage drops slowly in out instead of constant 30v
thanks
What you see in the waveform is the initial transient response, caused by charging the output capacitor through the boost inductor. There's no controlled boost operation involved so far.
To prevent this transient, which can cause unwanted overvoltage at the output, you can use a bypass diode from input to output.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.