Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How 3.3nH inductor provides 180deg phase shift?

Status
Not open for further replies.
T

Terminator3

Advanced Member level 3
Joined
Feb 25, 2012
Messages
802
Helped
71
Reputation
142
Reaction score
63
Trophy points
1,308
Activity points
9,027
I can't understand where it comes from. There is application note "Tuning the nRF24xx matching network", that says: inductor L1 provides 180deg phase shift at 2.4GHz. I came up with formula:
Code: 
L=50/(2*Pi*2.4)
	L = 3.315727981e0
yes, it is 3.3nH inductor, but why 180deg?
Isn't it 90deg?
I know, it is stupid, but i need help here.

For inductance i learned X=2piFL, current "slower" than voltage 90deg. Adding resistor, shift becomes <90deg
For capacitor X=1/2piFC, current "faster" than voltage 90deg..
 

Read the application note carefully; there is a balun involved with additional L's and C's
 

Attachments

  • match.gif
    match.gif
    20.4 KB · Views: 111
C8 and C9 provide a tuned circuit with L1 with the centre tap earthed, this give the 180 degrees phase shift across L1, unfortunately the output is only taken from one end!
Frank
 
A single-pole L or C circuit provides up to 90° phase shift per pole, and to get 180° phase shift, needs at least two poles (LC).
In phase shifter or lumped balun designs very common is to use three poles to provide a 180° phase shift (CLC or LCL).
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top