Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Circuit design-weather monitor

Status
Not open for further replies.

kumaresanv20

Newbie level 2
Joined
Aug 30, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
13
Hi friends,
I need a 3-input circuit design for monitoring analog inputs from Temp sensor, humidity sensor and gas sensor. The circuit should have the following,
1. ADC(flash or succesiv approx)
2. OP-amp
3. 8-bit processor
4. Bias circuitry
*Design would be simulated using PSPICE
*the digital output will be integrated with FPGA

It wil be really greatful if someone post a circuit that would help me out in my project
Thanking you
 
Last edited:

Select your sensors, follow the manufacturers suggestions to get all the 0 -100% ranges within a suitable analogue range for the ADC. Select a suitable analogue switch wire its control lines to the micro, connect ADC to micro. Whats the problem?
Frank
 

Sir i am new to the circuit designs, can I use Mux for the 3 inputs or is there any other solution
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top