Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pls help me for proteus transformer

Status
Not open for further replies.
C

Curious123

Newbie level 2
Joined
Aug 22, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
13
Untitled.jpg

can i use TRAN-2P3S for circuit shown in the diagram? because i nid to use center tap at the input of the transformer. can i juz invert it (X-Mirror) to get 3 input primary winding with center tap and 2 output secondary winding?

and i have the problem of missing circuit/package in physical partlist. how to solve it?

another question is how to configure the transformer in proteus? what should i put for the component value, primary inductance, secondary inductance and coupling factor?

the input of my transformer is 50V, 6.3A, 50Hz
the output of transformer is 230V, 1.4A, 50Hz
 

As a starting point, as Il on the primary is 1.4A, then Imag = 1.4/20 A, hence XLp = 230 X 20/1.4 . do the same for the secondary. If Rp = 3% of 230 /1.4, repeat for secondary. This will get you into the right ball court.
Frank
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top