Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Ultra leakage FET transistor for switch off battery?

Status
Not open for further replies.
C

carpenter

Full Member level 6
Joined
Jul 25, 2012
Messages
353
Helped
22
Reputation
44
Reaction score
24
Trophy points
1,298
Activity points
4,467
I have ultra low power MCU 0.9uA powered from small battery 3.7V 20mAh.
Now seeking a transistor to disconnect the peripheral with consumption 6uA.
In other words, seeking a FET in SOT23 with ultra low leakage in OFF, for 3V logic.
 

You'll find that the typical leakage current of small logic level MOSFETs like Si2301 is below 0.1 µA, but unfortunately the guaranteed (maximum) value is considerably higher. It's essentially the same with MCU idle current.
 

BSH105 ?
**broken link removed**
 

Since the power draw is trivial, why not use something
like an ACLV series logic gate (inverter, buffer, AND, ...)?
Good ones ought to have sub-uA static IDD and you can
shop on specs. Look at the single-gate logic families from
TI, NXP et al. That the output will also jam to ground,
might be good for eliminating "tails of misbehavior" that
might attend a leisurely, uncontrolled self-bleed-down.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top