Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Double Ridge to Quad Ridge transition

Status
Not open for further replies.
K

K&amp#305z&amp#305

Junior Member level 3
Joined
May 19, 2010
Messages
27
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Location
Ankara / Turkey
Activity points
1,429
Hi, I need to design double ridge to quad ridge transition. But, I have 2 double ridges, which are used for double polarization in quad ridge waveguide. How can I achieve transition?
 

you need to convert the two linear polarizations into one polarization. Some sort of mode converter. If the two polarizations are not coherent, u could just take off the two polarizations to two coax connectors, and power combine them.
 

But the problem is that: This Quad Ridge WG will be used for high power application and the frequency is high. There is no connector that can handle the power according to connector manufacturers. Therefore, I need to get the signal from amplifier which has double ridge waveguide end and then couple them.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top