Giri12
Newbie level 2
Hello everyone,
I have tried to communicate 2 microcontroller using CAN-BUS ,
It's worked . Now , I'm trying to turn light bulb using those 2 micro ( 1 micro as input , and the other as output )
I choose ULN2003 to drive 2 relay. but I got stuck!! The problems begin when I put the relay + ULN2003 in my shield.
I separated into 3 device :
1. Micro + CAN bus (I called "MCAN1" as Input)
2. Micro + CAN bus (I called "MCAN2" as output)
3. ULN + Relay Shield
When I sent some command to turn on light bulb , MCAN2 didn't respon. So , I remove the shield ,
and those 2 Micro can communicate again. May be someone have experience like this ? I need Help , it make me confusing with this ULN,,
Sorry for my bad english,,
Thanks,
Gee
I have tried to communicate 2 microcontroller using CAN-BUS ,
It's worked . Now , I'm trying to turn light bulb using those 2 micro ( 1 micro as input , and the other as output )
I choose ULN2003 to drive 2 relay. but I got stuck!! The problems begin when I put the relay + ULN2003 in my shield.
I separated into 3 device :
1. Micro + CAN bus (I called "MCAN1" as Input)
2. Micro + CAN bus (I called "MCAN2" as output)
3. ULN + Relay Shield
When I sent some command to turn on light bulb , MCAN2 didn't respon. So , I remove the shield ,
and those 2 Micro can communicate again. May be someone have experience like this ? I need Help , it make me confusing with this ULN,,
Sorry for my bad english,,
Thanks,
Gee
