Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
while coding in c in 8051 microcontrolller how should we put the value in code?by using datasheet of steppermotor or is there standard value for the code?
Hi,
U r connecting the stepper motor to some port pins right? Now you just make the purticular port pin to high or low as it is... it'll directly fetch into stepper motor connections...
For example, P0.1 = 0 means Port0.1 pin as low. So 0v 'll go to stepper motor at the purticular pin connection...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
