Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ABOUT unit gain buffer ...

Status
Not open for further replies.
S

super

Full Member level 2
Joined
Aug 18, 2002
Messages
125
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
904
unit gain buffer

Dear all :
I have question about unit gain buffer.
There are three type op.
1. General 2 to 1 op
2. telescopic op
3. folded cascode op

if I connect these op to unit gain buffer ,
what's the different both of them ?


Thanks ..
 

I think the key difference is the output voltage swing. For telescopic op amp, if you connect the input and output to implement a unity-gain buffer, the output swing is Vth4-(Vgs4-Vth2) [Razavi page 299]. But if you are using a folded cascode op amp, the output swing is higher than the telescopic op amp. Hope this will help. Sorry I am not famillier with the 2 to 1 op amp.
 

Do you mean the 2 to 1 op amp is the differential to single ended configuration?
 

sorry,,,
the 2 to 1 op amp is the differential to single ended configuration.

How about folded cascode and differential to single(D2S) Opamp ?
because folded cascode only open loop gain and Vomax folded is large than
D2S and Vomin are equal .
I don't know what's different between folded and D2S if connect to
Unit gain buffer?

Thanks .
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top