Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Atmega88 programming error.

Status
Not open for further replies.

stunningbasil

Newbie level 1
Joined
Aug 8, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
India
Activity points
8
With my usbtiny programmer i am not able to program atmega88 though i programmed atmega16 and attiny2313 with the same..
Its displaying device initialization error..
My programmer has 6 pin cable.. gnd,vcc,mosi,miso,rst,sck
Do i just need to connect these pins to the appropriate pins of the controller like in atmega16 or is there any other method..
PLEASE HELP..!!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top