Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Anyone has ever used stub tuner?

Status
Not open for further replies.
H

hebu

Full Member level 4
Joined
Nov 15, 2004
Messages
194
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
1,816
I use the stub tuner to generate the load of PA, to get the optimum load
impedance. But I want to get the right impedance at fundamental frequency
and the certain impedance at second order harmonic. How can I get this?

Besides, any material talks about how to use 3-stub tuner?

Anyone know the maury microwave?

Thanks,
 

hebu said:
I use the stub tuner to generate the load of PA, to get the optimum load
impedance. But I want to get the right impedance at fundamental frequency
and the certain impedance at second order harmonic. How can I get this?
Click to expand...

This behavior is on the nature of the tuner. I think you must accept different impedence at harmonics frequencies.

hebu said:
Anyone know the maury microwave?
Click to expand...

Few companies produces tuners, but, for my opinion, the quality of Maury products is better. Of course Maury is a bit more expensive.
 

You need a diplexer filter, lowpass and highpass ports, and two different stub tuners. The crossover frequency has to be somewhere between the output frequency and its 2nd harmonic.
 

Thanks,

Because I want to try different harmonic termination to PA, so
I need control the impedance at different harmoinc, fundamental, 2nd, 3rd..etc.

1)Maybe, diplexer is good idea, do I need to combine the two branch so that
I can get the true signal from PA?

2)May I control the impedances of 1st and 2nd harmonc in one stub tuner?
 

hebu said:
I use the stub tuner to generate the load of PA, to get the optimum load
impedance. But I want to get the right impedance at fundamental frequency
and the certain impedance at second order harmonic. How can I get this?

Besides, any material talks about how to use 3-stub tuner?

Anyone know the maury microwave?

Thanks,
Click to expand...

You need an harmonic tuner. The companies that produce it are Maury Microwave and Focus.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top