Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Where is hole or drill in MOUNT-PAD-ROUND3.0 from Eagle library? (prepare for fab)

Status
Not open for further replies.
T

Terminator3

Advanced Member level 3
Joined
Feb 25, 2012
Messages
802
Helped
71
Reputation
142
Reaction score
63
Trophy points
1,308
Activity points
9,027
Hello! I added MOUNT-PAD-ROUND3.0 from standard library named "holes", but where is the hole? I mean, i can see hole in the pad, but where it parameters that would be using fo drilling, i can see only center, without diameter. For me it is not obvious, how PCB shop will process my board. Should i do something with it or it is okay?

Update: sorry, i turned off some layers and now can select the pad and parameters. Before posting this message i tried to do it for two hours :smile:
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top