Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Proteus Ares line thickness

Status
Not open for further replies.
D

dmta

Member level 2
Joined
Mar 25, 2013
Messages
52
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Earth
Activity points
1,650
Hi all,

I have routed a PCB in proteus ares and now I want to increase the track width. At the moment I am just drawing lines in order to increase the width. But when I obtain the output PDF it can be seen that there are places where the copper is missing (attachments). So how to increase the track widths properly ?
 

Attachments

  • drv.bmp
    955.2 KB · Views: 113
  • drvH.PDF
    3.3 MB · Views: 126

You can easily increase or decrease the track width, Just go to track mode(Right hand side below package mode) and select the thickness you want. If you are not satisfied with the thickness you can make one of your own thickness.
 

Hey all I found it. Just use the zone mode (left side yellow "T" sign) and draw the shape you want.
 
  • Like
Reactions: dmta

    D

    dmta

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top