Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Sentaurus Device simulation problem:Why are the inner and outer gate voltage not same

Status
Not open for further replies.

Cherry Shan

Newbie level 3
Joined
Jun 28, 2012
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,302
Sentaurus Device simulation problem:Why are the inner and outer gate voltage not same

Hey everybody, I am a novice for the sentaurus, I am trying to use it to simulate a silicon-based MOSFET.
When I simulate the transfer characteristics of the device with the VGS=1.5V and VDS=0.05V, the drain current turns out to be constant.
And I found the outer gate voltage varies from 0 to 1.5V, however, the inner gate voltage varies from 0 to 6.5V!
I don't know why.
Any help would be truly appreciated.

Thanks,
Cherry
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top