Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Measuring a current from a stepper motor

Status
Not open for further replies.

RISCIT

Junior Member level 1
Joined
Dec 30, 2011
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,441
Hello guys,

I have a project in electronic which is to measure the current passing through the winding of a bipolar stepper motor, design an analog circuit and then convert the output value to this circuit with the help of a microcontroller which will have theses input configured in ADC Conversion,

I just want to know if you have an idea og how i can measure the current around the winding of a stepper motor, maybe use a shunt but it is not the same configuration of a DC Motor so i hop you will give some information about how we can do that, or better a schematic or a link where i can extract interesting information.


Thnk you!!
 

In a bipolar stepper driver, you can measure the current with low-side shunts. You may have noticed that stepper drivers are often operated in constant current mode. In this case, measuring shunts and a current control loop will be already present in the driver circuit.
 

Thanks for you answer,


But how can i interface my circuit to the stepper driver motor?, i just to have to shoot one cable from one phase of the bipolar, how can i take a measure of the current from the stepper and the put it in the input of a current voltage or voltage current converter
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top