Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

patch antenna simulation by using CST Microwave studio

Status
Not open for further replies.
K

key_

Newbie level 6
Joined
May 29, 2013
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,352
hai all ......

I decided to make a patch antenna and I need to design it in cst microwave studio...I am new to that software ....so how can i do the simulation..?
 

Thanks for your replay CG021079 .....

I also need more help about single feed corner truncated circular polarized patch antenna.....and how to improve the gain and bandwidth of such antennas......


Regards key_
 

you can check the folder c->cst>documentation (in your system). all manuals are available there.
 

Hi,

You can tried Antenna Magus, and then export the file to CST.

Regards
 

any one know what is a differance btw e plane and h plane pattern in cst and how i can plot these two pattern with cst
 

Amntt,
Here you can find good info about what you want to design:
https://www.jpier.org/PIER/pier80/03.07110604.pdf
E and H plane are just the definition of the two perpendicular planes where E and H are higher respectively ad you can observe rad pattern just by changing your view,(i.e phi =0 --> phi = 90)
Regards
Hadi

- - - Updated - - -

Alberto,
Do you have Magus? I just want an dual-reflector antenna design example for 1 GHz exported for FEKO. Can you help me for that?
Regards
Hadi
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top