Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

using IR to approximate distance?

Status
Not open for further replies.
B

bhan1992

Member level 1
Joined
Feb 25, 2012
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,511
hi,

i want to design a device to sense the distance between two objects.
for example, when the transmitter is near to the receiver, there will be a beep sound. as the transmitter and receiver gets closer, the beep sound will be come more frequent until a certain range the sound will just be on.
can this be done using IR transmitter and receiver with a PIC? or is there any other better ways of getting the task done?

thank you for your reply
 

What is the distance?

For distances of a few feet, an ultrasonic sound transmitter and sensor is often used since the slow speed of sound compared to light makes it much easier to measure the distance from the time the reflection takes to travel to the target and return to the receiver.

If you want to use light then the easiest would be to hack into one of the laser distance measurement devices sold in hardware stores.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top