Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

errors about ic5141 installed on redhat 9.0

Status
Not open for further replies.
zzczx

zzczx

Junior Member level 3
Joined
Sep 30, 2004
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
202
when I install ic5141 at redhat9.0, I follow gitarrelieber's article "How to install Cadence IC5.0.33 under Linux RedHat9", and the total time that i install ic5141 is more than 4 hours.;(
when I type icfb&, the following error comes out:
Incorrectly built binary which accesses errno or h_errno directly. Needs to be fixed.

what should I do for it?Does any one who have the experience share it ?
Thanks .
 

that's not big problem
look for the key word in your error message in EDAboard and you will find it (I just forget the detail ,haha)
good luck
 

qslazio said:
that's not big problem
look for the key word in your error message in EDAboard and you will find it (I just forget the detail ,haha)
good luck
Click to expand...
I had find the answer:):
Add this environment, assuming csh
setenv LD_ASSUME_KERNEL "2.4.1"
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top