Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me USB to RS232/RS485 converter problem

Status
Not open for further replies.
udhay_cit

udhay_cit

Full Member level 6
Joined
May 16, 2008
Messages
346
Helped
37
Reputation
74
Reaction score
37
Trophy points
1,318
Activity points
3,895
Dear friends,
I am designing a multipurpose converter. we can configure it as follow
1. USB to RS232
2. USB to RS485 (4 Wire)
3. USB to RS485 (2 Wire)
4. RS232 to RS485 (4 Wire)
5. RS232 to RS485 (2 Wire)

USB to RS232 is working properly. Now my problem is when i use USB to RS485 (4wire) i am getting echo signal from RS485 terminal.
When i connect a RS232 to RS485 converter externally, its working properly. Now i hope the problem comes from RS485 converter & more specifically from TX,RX selection pin(I don't know, it may be wrong).

Here i attached the schematic diagram can anybody please give me an advise to solve this problem...
Thanks in advance

Regards
Udhay
 

Attachments

  • usb to rs232.pdf
    19.2 KB · Views: 79

When you configure it for 4wire RS485, do you pull the Receiver-Enable for the RS485 tranceivers (your CBUS3) low constantly?
Because if you do then you are enabling the receiver circuit of U4 which will then echo back whatever is sent.
 

Yes there is a 10k pull up resistor available for receive enable(CBUS3)...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top