Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Fan Revolution Counter

Status
Not open for further replies.
I

ibwev

Newbie level 5
Joined
May 12, 2013
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Shreveport, LA
Activity points
1,361
I am trying to find the most affordable and reliable method of counting the revolutions of a 2.5" diameter fan (see pic) using a micro-controller. Currently, I am using a light sensor (GP2A200LCS0F) which cost over $5 per sensor. Is there a cheaper, yet dependable, component for this?

IMG_20130612_231308.jpg
 

Depends a bit on what type of fan that is?

For some types, you can use the commutation current profile to generate a pulse for each commutation. Divided by the amount of commutations/windings you get RPM.
 

Ice-Tea said:
Depends a bit on what type of fan that is?
Click to expand...

It is a 2.5" diameter plastic fan connected to a bearing. I am using it to measure air current across the blades. It is not powered by a motor.

Ice-Tea said:
... commutation current profile to generate a pulse for each commutation.
Click to expand...

Does this method only work on fans powered by a motor?
 

Does this method only work on fans powered by a motor?
Click to expand...
I presume it's a BLDC motor with built-in electronics. The BLDC can be used as a synchronous generator, but you need to remove the electronics and connect a winding directly. I don't expect that you get a usable signal at the open supply pins, but may be worth a try. Removing the electronics will however reduce an electrical breaking effect by the BLDC generator load.
 

FvM said:
I presume it's a BLDC motor with built-in electronics.
Click to expand...

There is not a motor connected to the fan. The fan only revolves when air is forced across the blades. I am currently using a light sensor to count the blades. Is there a better method?
 

This is a very nominal requirement. You should be able to use an IR LED and a photo diode, they both come very cheap.

Just reverse bias the photo diode (Anode to ground, cathode thru' 2.2k to Vcc), and the junction of the cathode and the resistor would be able to drive your CPU directly.

Regards,

Anand
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top