Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Getting execution error in HFSS

Status
Not open for further replies.
E

Ejaz484

Junior Member level 2
Joined
Oct 26, 2010
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,425
Hi,
I have to analysis a mode selector which has three modes TE01, TE02, TE03. Can anyone suggest whats steps to be followed to get the result without an error??
My Input signal frequency for mode selector is 42GHz. I have designed and executed it. But iam getting message "Analysis completed with some execution error".
What I have to do to remove this??
 

I am encountering the same error. I have 8 patch antennas mounted on the cylindrical surface. I am feeding them using stripline structure and there are 3 substrate layers. two for the striplines and third , on which the antennas are wrapped around. I am seeing this error. Unexpected error encountered in the meshing process''.How can I remove it?
 

These errors generally suggest something isn't set up quite right in your project. I suggest you contact your local ANSYS AE, and have them look at the project. If nothing else, then you need to post MUCH more detailed information here on the project and the error.
 

Thanks for your suggestion sweet jimmy
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top