Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

use of ir2184 to igbt inverter

Status
Not open for further replies.
B

bharath210

Newbie level 2
Joined
May 16, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
hello everyone
iam using ir2184 gate driver for igbt inverter.my problem is ir2184 ic is getting heated whenever i switched on the supply through iam giving 15v supply.it is showing voltage b/w com pin and vcc as 15v but b/w com n vb pin it is showing 35v.so what is the problem can anyone help me thank u.iam attaching the circuit fileView attachment gate ckt.doc
 
Last edited:

where is your circuit?

- - - Updated - - -

Logic input for shutdown voltage cannot be +15v change to a +5v. It has a resistor inside the IC that pulls the pin to +5V if you do not connect it. Also use a 1k res between the mosfet gate and source.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top