Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Micro's current draw goes up when its Vdd rail goes near the threshold...why?

Status
Not open for further replies.
T

treez

Guest
Hello,

We are using the Atmel SAM3N00B micro.
We set the supply monitor to 3V.
Why is it that when the micro's supply rail gets near 3V its current draw goes up by 3mA (from 1mA to 4mA)?

SAM3N00B MICROCONTROLLER DATASHEET:
http://www.atmel.com/Images/doc11011.pdf
 

When you are below the threshold, the device is asleep, isn't it? I think that's the whole point of the supply monitor, to shut the chip down when the power falls. Obviously, it draws more current when it's running than when it's asleep.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
ok but the current peaks up as it falls to the supply threshold, then goes back down again as the supply rail falls further
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top