Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help with a CMR issue

Status
Not open for further replies.
E

eladta

Newbie level 5
Joined
Apr 20, 2013
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,342
Hi all,
As u can see in the attached circuit there is a resistor in the cathode side and one in the anode side.
The question is why not to put one equivalent resistor equals to the series sum of them (when the led is on lets assume it's a short) ?
I know the answer has something to do with CMR but i didn't get it.
Thanks.

acpl.jpg
 

If you are trying to get rid of common mode signal, you need to put similar impedances (resistance ) for both the inputs. This way, at the input of the photo diode you cancel out the common mode.
 

shab_eda said:
If you are trying to get rid of common mode signal, you need to put similar impedances (resistance ) for both the inputs. This way, at the input of the photo diode you cancel out the common mode.
Click to expand...

i understand that this combination of resistors cancal the common noise but i don't understand why..
 

The common mode noise gets cancelled because the input is differential not because of the resistors. The resistors are added to limit diode current.
 

I see no reason for two resistors. The CMR is provided by the opto coupler, not the resistors. One equivalent resistor should work fine.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top