Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SIM900 Microphone Issue

Status
Not open for further replies.
S

sreeram25

Newbie level 2
Joined
Mar 1, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
Hi,

I connected PWM output (VOUT1 and VOUT2) pins of aP8942A (pre recorded voice) to SIM900 MIC pins via filter circuit.

When I first power on the board and make a call to SIM900 I am not able to listen the voice.

After that if I power OFF and ON the module, I am able to listen the voice.

Reset by using PWRKEY,NRESET is also not helping. Microphone works only after I power off and on module.

To again re-produce the issue, I had to power off the board for 15 mins and then power on.

Regards,
Sreeram
 

There's a chance your source device is sending a glitch to the receiving device, causing it to malfunction.

A likely type of glitch would be a negative spike, or else a positive spike which is greater than the supply V.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top