Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Floating point calculation in MWS?

Status
Not open for further replies.

irfan1

Full Member level 5
Joined
Oct 26, 2003
Messages
294
Helped
25
Reputation
50
Reaction score
10
Trophy points
1,298
Activity points
2,872
Is it possible to switch between floating point and double precision in MWS? I know from my experience with other software that floating point calculation may increase the speed a lot and reduce the memory requirement. Still the accuracy of the calculations arent to bad at all.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top