Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Coplanar Waveguide with Ground via placement

Status
Not open for further replies.
S

salmanmahmood

Junior Member level 3
Joined
Aug 17, 2012
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,510
Hi all,

I need to make a coplanar waveguide with ground and I need to know what via spacing to use for strapping the ground to the ground plane. My operating frequency is 1900 MHz (Using GSM). Are there any calculations which can be used for this purpose?

Thanks in advance,
Regards,
Salman
 

Hi,

I went through these documents before. They dont provide guidelines on via placement.

Regards.
Salman
 

I read some where, where they said that from copper edge to drill should be 1 time the via drill size..But could not find that reference...
 

For your frequency, you can space the via pitch equal to or less than 0.080" and you'll be fine. Have the vias so that the hole edge is a distance equal to or less than the trace width. Sparing the theory, because it is really involved, but for a quick and dirty answer for what you need, you'll be fine with these rules. Things get a lot more interesting at higher frequencies.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top