+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Junior Member level 2
    Points: 924, Level: 6

    Join Date
    Oct 2012
    Posts
    20
    Helped
    0 / 0
    Points
    924
    Level
    6

    Place ground in orCAD capture

    When I place GND in capture, it appears two libraries on the "place ground" dialog block which are" CAPSYM" and "Design Cache".
    I have some questions as below:
    1. CAPSYM: what's the difference between GND & GND_POWER ? how to use them?
    2. Design Cache: why are there more than 5 GND in the cache while I just used 1 ?
    Learn more.

    •   Alt12th March 2013, 11:29

      advertising

        
       

  2. #2
    Full Member level 5
    Points: 2,811, Level: 12

    Join Date
    Jan 2007
    Location
    Hyderabad
    Posts
    316
    Helped
    46 / 46
    Points
    2,811
    Level
    12

    Re: Place ground in orCAD capture

    Both are same.it refer to GND.If you want yo have two nets in design then use two different symbols otherwise use only one...

    Right click on design cache and select cleacup cache..


    1 members found this post helpful.

--[[ ]]--