Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Sallen key filter design,low pass

Status
Not open for further replies.
B

botthe.

Newbie level 4
Joined
Feb 7, 2013
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,334
HOW TO DESIGN SALLEN KEY LOW PASS FILTER FOR 10Hz WITHOUT INCREASE IN THE GRAPH OF FREQUENCY MAGNITUDE PLOT AFTER 5KHz.
I GOT GRAPH AS attached. HOW T low.PNGO GET IT DECREASING THROUGHOUT OR ATLEAST DECREASING TILL 1MOhm.
 

This is a typical disadvantage of the S+K lowpass.
If necessary, choose another filter topology.
 

You can improve matters by picking your values better to minimize the higher op-amp output impedance effect at higher frequencies.
By making all capacitors 10 times smaller and the resistors 10 times larger, you get a much better response.
 

Attachments

  • SK_filter.gif
    SK_filter.gif
    36.4 KB · Views: 115

These values seems to work okay.



The screenshot was snapped when the frequency was 11 Hz. As seen by the scope trace, the output has begun to diminish.

The sweep shows no abnormal activity above 5 kHz.
 

BradtheRad said:
.............
The sweep shows no abnormal activity above 5 kHz.
Click to expand...

No surprise. I think it`s hard to detect some signals in the time domain if they are 50...60 dB down.

- - - Updated - - -

E-design said:
You can improve matters by picking your values better to minimize the higher op-amp output impedance effect at higher frequencies.
By making all capacitors 10 times smaller and the resistors 10 times larger, you get a much better response.
Click to expand...

As an alternative and if you are allowed to use a second opamp, you can insert a unity-gain amplifier into the feedback network.
Then there is do signal entering the filter output through the feedback capacitor.
 

try using some other configuration like Multiple feedack filter!!
or else play with the values for better result increase or decrese values of resistor /capacitor by same ratio
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top