Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

rotating conveyor belt

Status
Not open for further replies.

Lalitp

Junior Member level 2
Joined
Sep 11, 2012
Messages
20
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,395
I want to design a continuous rotating conveyor belt which have a speed of 2mm/sec.
What hardware will required.?
Motor type.?
Gears.?
Any mathematics.?

Only one side will be a motor, other side will be only simple rotor.
I want to save myself from programming..
 
The power rating of the motor will depend on the size and load on the belt.

For a slow belt speed, you may get by with a small motor running at high speed. Use a large gear ratio. The gearing amplifies torque while it steps down speed.

The motor drives one gear on one roller at one end of the belt loop. All other rollers can be idlers.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top