Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Diff. betw. timing-driven,non-timing-driven P&R in A
In placement and routing point of view, the time-driven means that the tool should be considered some restrictions on timing and it can not place and route the components anywhere. But in non-timing driven, there is not any limitations on timing and the placement of the component cab considered anywhere in the floorplanning.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.