Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is it a trial and error method to parameterize a new VFD for a operation ?

Status
Not open for further replies.
P

phatcreators

Full Member level 5
Joined
Sep 2, 2011
Messages
315
Helped
24
Reputation
48
Reaction score
24
Trophy points
1,298
Activity points
3,458
Is it a trial and error method to parameterize a new VFD for a operation ?

so for parametrizing a new drive for a motor for a new process or working , do we have to use trial and error method for selecting the right kind of control method (whether Open loop , closed loop , v/f etc) and also the acceleration & deccelaration times ?

right ???
 

I think, the essential parameters will be defined as part of mechanical engineering normally. If mechanical engineering is using trial and error methods instead of profound calculation, VFD commisioning will take the same approach.
 

FvM said:
I think, the essential parameters will be defined as part of mechanical engineering normally. If mechanical engineering is using trial and error methods instead of profound calculation, VFD commisioning will take the same approach.
Click to expand...

What do you mean by that ?

I'm just asking about acceleration , decceleration & choosing of control method parameters only .....
 

You are asking about all essential VFD parameters. I say, that the mechanical engineer designing a machine (or planning a reconstruction) should be able to tell you the parameters, if he is working based on calculations.
 

FvM said:
You are asking about all essential VFD parameters. I say, that the mechanical engineer designing a machine (or planning a reconstruction) should be able to tell you the parameters, if he is working based on calculations.
Click to expand...

I think trial and error is not the right terms to ask , i would rephrase my question like that , for , fine tuning of a VFD parameters we can use trial and error technique lets suppose set or factory setting values of acceleration and decceleration times is 5 sec each ..... but they are not giving the right acceleration and decceleration times then i would try to increase them from 5.1 sec to 6 sec to see any betterment in the acceleration and decceleration times of a VFD as per the process and operation of that motor .

Is this the right way ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top