monna
Newbie level 3
hello..
i am interfacing 8051 to xbee (tharang f4-it is a module from NSK )using max232 ic. when i connected the xbee to PC it works properly at 9600 .
I programmed 8051 to sent hello word at 9600 .when i connected 8051 to pc at9600 it works fine.but when i connected to pc through xbee(8051-232-232-pc) it doesn't work.where is the problem?
1)i am not using any AT commnds in the 8051. i am simply sending hello to uart. is any mistakes in the steps?is ATcommand necessary to communicate with 8051and xbee?
please help me.
i am interfacing 8051 to xbee (tharang f4-it is a module from NSK )using max232 ic. when i connected the xbee to PC it works properly at 9600 .
I programmed 8051 to sent hello word at 9600 .when i connected 8051 to pc at9600 it works fine.but when i connected to pc through xbee(8051-232-232-pc) it doesn't work.where is the problem?
1)i am not using any AT commnds in the 8051. i am simply sending hello to uart. is any mistakes in the steps?is ATcommand necessary to communicate with 8051and xbee?
please help me.
Last edited:
