Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Tuning antenna with SWR meter

Status
Not open for further replies.
D

Drew

Newbie level 4
Joined
Nov 15, 2004
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
67
swr meter connect

I'm trying to tune an antenna to work at 13.56 MHz. We've got a SWR meter at school with only one input. However, the antenna manual I've been reading says that I need to tune the antenna using a SWR meter with 2 inputs - one for the antenna and the other for the transmitter (in my case, an RFID reader). Does that mean that using the SWR meter at school is a non-starter?
 

using a swr meter

The meter you use at school may have an internal oscillator. You can test it with a 50 ohm resistor and then an open and then a short circuit. You should get 1 for the first and infinity for the second two terminations.
 

I think somewhere is a misunderstanding.
Probably the SWR-meter with one input what you said, is actually a basic RF power meter with internal load.
You need a standard antenna SWR-meter, with one input (for transmitter) and one output (where you connect the antenna).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top