Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Create Path showing DRC rules

Status
Not open for further replies.
R

relax4567

Newbie level 3
Joined
May 10, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
Hi

I am drawing the layout of my circuit using Virtuoso. I am using create path command to connect different blocks.
By mistake I pressed some key. Now, when I draw a path it shows the DRC rules ( like minimum metal width, minimum spacing) which makes the layout drawing easier.
I tried to figure out how I should setup the Virtuoso to do this but I could not.

I rally appreciate if someone can help me with this.

Thanks
 

May be this may help you?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top