Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Detection of phase availability in delta 3 phase system

Status
Not open for further replies.
O

ocsee

Newbie level 4
Joined
Mar 12, 2010
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
baroda
Activity points
1,313
I need your help regarding Three phase(delta connection) detection ckt with optocoupler.

I want to sense phase is available or not.

Just like attached ckt.

So question is,
Attached ckt will work for 440v phase to phase? three phase detection ckt.PNG
 

I am extremely unhappy with this circuit. If only one phase is active, then only one opto is on and only one transistor, but with your component values, the output will be a '0'. Well actually a '.5' because of the 1k emitter resistor. I would try putting all three transistors in series, no emitter resistor and proportion Rc so that with all three phases present, the Vc of the 'top' transistor is .6V (3 X Vsat). Then if a phase goes missing, the voltage at this point will rise. I do not think your series resistors are high enough in value, I feel 1M would be safer.
Frank
 

Thanks for reply,

I am just interested for i/p connection of three phase for detection.

O/p ckt and Resistor values are different.

So, please tell me is it work?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top