Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Zsp vs. Zparameters in IE3D

Status
Not open for further replies.
A

akalestos

Newbie level 2
Joined
Nov 19, 2004
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
19
Dear all,

I have a two-port configuration and I have some questions to ask :
-What is the purpose of the Zsp(i,j) set of parameters?
-Which set of Zparameters gives the mutual resistance between the two ports?

Thanks in advance
 

hi,z(1,2) and z(2,1) give u the mutual coupling that if the two object are similar,but i suggest to obtain s(1,2) and s(2,1)
regards
 

Hi abdoeng and thanks for replying.

I am aware that z(1,2) give the mutual coupling between the two ports but in IE3D there are two set of Zparameters : The classical Z(1,2) and Zsp(1,2) (Z for S parameters). I was wondering what is the difference between those two and which of the two sets should I use in order to obtain the mutual resistance!

Thanks anyway!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top