t0m
Junior Member level 1
I have been having good results with a new toner transfer technique. Put a heavy hotplate on the stove and dial in a temperature of 175 °C using a thermocouple. Bond the toner image to the copper clad board by placing them print side down onto the hotplate between two sheets of paper and applying pressure with a rolling pin for 2-5 minutes. For double sided boards, flip every 30 seconds or so.
https://smokedprojects.blogspot.com/2012/12/diy-pcbs-by-toner-transfer.html
https://smokedprojects.blogspot.com/2012/12/diy-pcbs-by-toner-transfer.html