Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to interface Lumex LCM-S01602DTR/B

Status
Not open for further replies.
M

muneebziaa

Newbie level 5
Joined
Sep 13, 2012
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,359
Hi all,

I am using ml403 FPGA board and Lumex LCM-S01602DTR/B is built on the board, i have found out how to initialize it but can't figure out how to use second line of the LCD. if some one here have interface this LCD with any controller or can give me any detail on this LCD. I couldn't find its datasheet any where expect of few datasheet which shows its pin configuration.

My basic problem is I couldn't find the command instruction list of this LCD. If some one can provide me this instruction list of this LCD i will be thank full to him.

Regards,
Muneeb
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top