Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
As a strict upper limit, it must be the number of paths in the design, right? For a practical limit, it must be tool dependent. I imagine for a modern tool, it's pretty large, but I'm afraid I can't answer better than that. Have you hit this limit? If so, what was it and for which tool?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
