Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to make Ares do only bottom routes?

Status
Not open for further replies.
A

arschleben

Junior Member level 2
Joined
Feb 6, 2003
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
213
Need some help with Ares

Hi everyone, recently I developed a very simple circuit with Isis and after simulation I have netlisted to Ares, made the neccesary adjustments on position of the components, etc. But when Ares made the autoroute sequence, it traces the routes in top and bottom, unfortunaly I just want bottom routes, I have tried many components positions but it does not make any difference, so anyone have an idea how to make the Ares do only bottom routes?

Thanks!
 

Re: Need some help with Ares

From the 'Set Strategies' command specify your layer pairs as both being bottom copper.

You will need to adjust this as required on a per strategy basis within this dialogue.

Iain.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top