Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

help with astable multivibrator with 555 timer

Status
Not open for further replies.
F

fatemehgh

Newbie level 1
Joined
Oct 31, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Untitled.png
hi
i've just registered and have a emergency question .
i modeled a astable multivibrator with 555 timer in orcad but it showed this error
convergence problem in bias point calculation, then i enabled skip the initial tran... but now i see this error!"There are no data values in section #1 ignoring this section"
and here is my schematics'
looking forward for your answer.
Thnx.
 

Your schematic has a resistor on the output pin 3 which appears to go to ground...

However there is a red dot over the ground symbol. I think this is where the error is. Notice the other ground icons have no red dot.

I wonder if you ran the resistor and ground together, such that the ends appear to be connected...

Whereas the simulator does not recognize it as such?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top