Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Expedition PCB from Design Capture: Job Wizard: Failed to copy all files. Help needed

Status
Not open for further replies.
S

svia

Member level 3
Joined
Feb 7, 2008
Messages
61
Helped
10
Reputation
20
Reaction score
9
Trophy points
1,288
Activity points
1,774
Hi, I'm very new, but please, I need some help

After designing with Design View of Mentor's an schematic, compiled with CDB, and no error appeared. I tried to open in PCB, from Design View, and directly from Expedition PCB, but the error

Job Wizard: Failed to copy all files appeared.

In PCBPlatform translation.txt
Filename: "C:\Mentor2005\Work\Rafting_prueba\PCB\Work\template.prj"

***** Conversion failed. One or more paths were not converted. *****

Filename: "C:\Mentor2005\Work\Rafting_prueba\PCB\Config\PlotSetup.gpf"

***** Conversion failed. One or more paths were not converted. *****

Please, why could this error appear?
 

When using JobWizard to copy a design, make sure that nobody is accessing the design. JobWizard will fail if anyone is locking (using) any file in the design tree.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top