Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] help me to find vout in this circuit

Status
Not open for further replies.
D

diaz080

Member level 4
Joined
Oct 3, 2012
Messages
73
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,714
bhj.png

pls help me to find vout..
vb =.5v
take any values for u,cox,w/L..etc..
VDD=3v
Vt=.7v
 

For different values we get different answers and we are not here to argue whose is right here
 

Vb and Vdd don't match up some thing is still missing for us to guide you further

Better try some books here they will be useful to you
 

You will get only intelligible answer to this question

What is that is it an NPN and PNP connected in reverse direction or an NMOS AND PMOS connection
 
one second i did not see that the top fet was a PNP,

this circuit is incomplete, since Vb is a low for the PNP it will output a high voltage, in this case 1.2 Volts.
however if Vin is a low it will act as a ground for the Vout, if Vin is a high the voltage should be 1.2 volts,

so unless my theory is wrong if: Vin > .7 Volts, then Vout = 1.2 volts
Vin < .7 Volts, then Vout = 0.
 
Last edited:

Even I am not clear about it pal Some people when drawing free hand draw it like that

I may even be wrong
 

It sounds like this is for school because its such a small circuit so, if the answer is asking for Vout range, then
the vout is based on the Vin values which i gave.
 

i dnt want 2 knw d exact answr,need 2 knw d steps. 2 fnd vout n then vin
Click to expand...
Please don't write at this style because it is really hard to understand .
 

You must skim through the Rules of the forum it is against a bunch of rules to post contents like this
 

problem solved.circuit was incomplete..sorry

- - - Updated - - -

but at least u guys could have given me advice about small signal analysis :cry:
 

LvW said:
I hope nobody will answer to this attempt for writing something.
Click to expand...
oh really :???: i couldn't figured it out,it was a doubt asked by my friend.and i thought u guys will help me to get this stuff solved.

- - - Updated - - -

nmos transistor was supposed to be connected in the back side of the pmos which will give the current mirror pattern
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top